Mildenhall Roofers carries out all types of roof repairs in Beck Row, from a single slipped tile to storm damage affecting large sections of a pitched or flat roof.
Call any time. Calls are answered day and night and passed straight to our roofers.
Most roof problems give you warning signs before water gets inside. The difficulty is that the signs are easy to miss from the ground, and by the time a damp patch appears on a ceiling, damage has often been building for weeks or months. Understanding what to look for can save you a significant repair bill.
We carry out roof repairs across Beck Row and the surrounding area, including Mildenhall, West Row, Barton Mills, Icklingham and further afield. No job is too small, and catching a problem early almost always means a simpler, cheaper fix.
Walk around your property and look up. Slipped, cracked or missing tiles are the most obvious sign, but there are others worth checking. Moss and lichen growth can lift tile edges over time, allowing water to track underneath rather than run off cleanly. Dark patches or uneven colour across a roof section can indicate that an underlying felt layer has broken down.
Sagging anywhere along a ridge line or between rafters points to a structural issue, not just a surface one. Damaged lead flashing around a chimney stack, dormer or roof valley is a common source of leaks because the seal between the roofing material and a vertical surface is always under stress as the building moves with temperature changes.
Check your loft space after heavy rain. Water stains on rafters, wet or compressed insulation, and any smell of damp are all indicators that water is getting through somewhere. A loft inspection is often the quickest way to pinpoint where on the roof the problem is starting.
Damp patches or tide marks on ceilings, particularly in corners or near chimney breasts, usually point to flashing failure or a cracked tile directly above. Peeling paint or wallpaper on a top-floor wall can also be water tracking down from a roof junction rather than rising damp from below.
Age is the most straightforward cause. Mortar on ridge tiles becomes brittle over time and eventually cracks or falls away, leaving the tiles loose. A common problem on older roofs is that the nibs on concrete interlocking tiles snap, allowing the tile to slide down the batten. Slate roofs can suffer from nail sickness, where the fixing nails corrode and slates drop without the tile itself being cracked or damaged.
Wind is a major factor. A storm that brings strong gusts can lift tiles that were already loose and drop them, or shift ridge tiles that had already lost their mortar bed. The damage is often not uniform across the roof, which is why a proper inspection rather than a quick look from the ladder matters.
Thermal movement affects flashings in particular. Lead expands and contracts with temperature. If a flashing was dressed too tightly or the lead was fixed without adequate clips, it will eventually pull away from the wall, leaving a gap. Even a small gap is enough to allow water to track behind the flashing and into the roof structure.
Flat roofs have their own failure modes. Felt flat roofs typically last 10 to 20 years depending on specification and condition. As the felt ages it becomes brittle and prone to cracking, especially where it bends over a drip edge or around a pipe outlet. Joints and seams are usually the first point of failure. EPDM rubber flat roofs are more durable, but can still suffer punctures or seam failures that need prompt attention.
Pitched roofs covering homes in Beck Row and nearby villages are tiled or slated, with ridge tiles bedded in mortar or mechanically fixed. A repair to a slipped tile involves lifting adjacent tiles where necessary, re-fixing or replacing the damaged tile, and checking the batten and underlying felt before closing up. Replacing a few tiles is not a long job, but it needs to be done carefully to avoid disturbing more tiles and creating new problems.
Ridge tile re-bedding involves raking out the old mortar, cleaning the ridge, and laying a fresh mortar bed before repositioning the tiles and pointing up the joints. On some roofs it makes sense to replace old mortar-bedded ridges with a dry-fix ridge system that uses purpose-made clips and a ventilated union, removing the mortar joint that will eventually fail again.
Garage roofs and flat-roofed extensions are among the most frequently repaired structures because felt ages and splits, particularly at laps and edges. Small splits and blisters can sometimes be repaired with compatible patching material, but if the felt is generally aged and brittle across the whole surface, a patch will not hold reliably and a full re-cover makes more sense.
EPDM rubber is now a common choice for re-covering a flat roof because it is flexible, handles temperature extremes well, and a well-fitted single-piece membrane eliminates most of the seam failures that trouble older felt systems.
Lead flashing repairs are one of the most effective things you can do to stop a persistent leak. Flashing that has pulled away from a chimney or dormer can often be re-dressed and re-pointed without replacing the whole lead, provided the lead itself is not cracked or too thin. Where lead has cracked or split it needs to be replaced in sections. Chimney stacks also need their haunching, the mortar that slopes away from the stack at roof level, to be in good condition. Cracks in the haunching let water sit against the brick and track down inside the chimney or into the roof structure.
A small roof defect left unattended can lead to wet insulation, timber decay in rafters and battens, and eventually damage to plasterboard ceilings. The cost of repairing the roof itself is almost always lower than the cost of repairing everything the water has reached. If you have noticed any of the warning signs described above, call us to book a roof survey in Beck Row or anywhere nearby.
No obligation · We'll call you to arrange a free visit
Call any time. Calls are answered day and night and passed straight to our roofers.